Cisco – Show the configuration of a single interface

Written by James McDonald

September 16, 2013

The problem (and benefit) of being the single IT guy for a company is that you are responsible for all the IT stuff. But if you only configure a Cisco Switch every blue moon then you are likely to forget some of the simpler command line stuff that makes it easier to configure a switch. So I’m leaving this here for my later memory jogging.

How to show only a single interfaces configuration

# show running-config interface gi0/2

show_single_interface_configuration

 

0 Comments

Submit a Comment

Your email address will not be published.

You May Also Like…

ZPL SBPL

Zebra Printer Language http://labelary.com/viewer.html The above website has a page where you can enter ZPL and it...

PHP Iterators

Just came across a Youtube talk "Iterators in PHP" by Jake Smith published in 2014 that steps through the many...

PHP array_map Multiple Arrays

array_map can take multiple arrays. I like how it starts mapping through them starting at the first element of each...